Experimental study of solar air heater with C shaped ribs coated with zeolite

Original scientific paper

Authors

  • Sureshkumar Petchimuthu Department of Mechanical Engineering, Government College of Engineering, Tirunelveli 627007, India https://orcid.org/0009-0008-7617-5612
  • Sathiya Moorthy Rajendran Department of Mechanical Engineering, Anna University Regional Campus, Coimbatore 641046, India https://orcid.org/0000-0001-9754-7800

DOI:

https://doi.org/10.2298/CICEQ231230010P

Keywords:

C-shaped ribs, perforations, zeolite coating, thermal performance, friction factor

Abstract

A study was conducted to determine the heat transmission rate and friction properties of a solar air heater's (SAH) absorber by including c-shaped rib, with and without perforations, and the efficiency of this absorber with and without zeolite coating was investigated. This research is carried out by varying Reynolds numbers (Re) ranges between 3000 to 18000, height of the C-shaped rib (e) ranges between 2 mm to 4 mm, and the embedded hole diameter in the c-shaped rib ranges between 1 mm to 3 mm. The impact of rib height, hole diameter, and zeolite coating on thermal efficiency and Nusselt number is compared to a flat channel under the same flow environments. A strong secondary flow is created by the free shear layer reattaching more often at higher rib heights, and a smaller hole can exaggerate heat transfer and enhance the cross-flow effect. The thermal efficiency and Nusselt number of the solar air heater with c-ribs (Rib height = 4mm and hole diameter = 1mm) and zeolite coating on the absorber increased by 29.67% and 62.16% over the flat absorber. Ribs 4mm high can increase duct friction by up to 3.1 times compared to a smooth duct.

References

S. Yadav, M.Kaushal, Varun, Siddhartha, Exp. Therm. Fluid Sci. 44 (2013) 34–41. https://doi.org/10.1016/j.expthermflusci.2012.05.011

A. Lanjewar, J.L. Bhagoria, R. Sarviya, Exp. Therm. Fluid Sci. 35 (6) (2011) 986–995. https://doi.org/10.1016/j.expthermflusci.2011.01.019

N. K. Pandey, V.K. Bajpai, Varun, Sol. Energy 134 (2016) 314–326. https://doi.org/10.1016/j.solener.2016.05.007

R.P. Saini, J. Verma, Energy 33 (8) (2008) 1277–1287. https://doi.org/ 10.1016/j.energy.2008.02.017

Varun, R.P. Saini, S.K. Singal, Renewable Energy 33 (6) (2008) 1398–1405. https://doi.org/10.1016/j.renene.2007.07.013

A. Kumar, J.L. Bhagoria, R.M. Sarviya, Energy Convers. Manage. 50 (8) (2009) 2106–2117. https://doi.org/10.1016/j.enconman.2009.01.025

M.K. Sahu, R.K. Prasad, Renewable Energy 96 (2016) 233–243. https://doi.org/10.1016/j.renene.2016.04.083

D. Jin, M. Zhang, P. Wang, S. Xu, Energy 89 (2015) 178–190. https://doi.org/10.1016/j.energy.2015.07.069

A.S. Yadav, J.L. Bhagoria, Int. J. Therm. Sci. 79 (2014) 111–131. https://doi.org/10.1016/j.ijthermalsci.2014.01.008

K.R. Aharwal, B.K. Gandhi, J.S. Saini, Renewable Energy 33 (4) (2008) 585–596. https://doi.org/10.1016/j.renene.2007.03.023

M.M. Sahu, J.L. Bhagoria, Renewable Energy 30 (13) (2005) 2057–2073. https://doi.org/10.1016/j.renene.2004.10.016

V.S. Hans, R.P. Saini, J.S. Saini, Sol. Energy 84 (6) (2010) 898–911. https://doi.org/10.1016/j.solener.2010.02.004

H.K. Ghritlahre, P.K. Sahu, S. Chand, Sol. Energy 199 (2020) 173–182. https://doi.org/10.1016/j.solener.2020.01.068

Y. Agrawal, J.L. Bhagoria, V.S. Pagey, Mater. Today Proc. 47 (2021) 6067–6073. https://doi.org/10.1016/j.matpr.2021.04.623

A.P. Singh, Varun, Siddhartha, Exp. Therm. Fluid Sci. 54 (2014) 117–126. https://doi.org/10.1016/j.expthermflusci.2014.02.004

R. Kumar, S.K. Verma, M. Singh, Mater. Today Proc. 44 (2021) 961–967. https://doi.org/10.1016/j.matpr.2020.11.006

Z. Jelonek, A. Drobniak, M. Mastalerz, I. Jelonek, Sci. Total Environ. (2020) 141267. https://doi.org/10.1016/j.energy.2022.125507

B. Bhushan, R. Singh, Sol. Energy 85 (5) (2011) 1109–1118. https://doi.org/10.1016/j.solener.2011.03.007

S. Alfarawi, S.A. Abdel-Moneim, A. Bodalal, Int. J. Therm. Sci. 118 (2017) 123–138. https://doi.org/10.1016/j.ijthermalsci.2017.04.017

A.M. Ebrahim Momin, J.S. Saini, S.C. Solanki, Int. J. Heat Mass Transfer 45 (16) (2002) 3383–3396. https://doi.org/10.1016/S0017-9310(02)00046-7

A. Lanjewar, J.L. Bhagoria, R.M. Sarviya, Energy 36(7) (2011) 4531–4541. https://doi.org/10.1016/j.energy.2011.03.054

S.B. Bopche, M.S. Tandale, Int. J. Heat Mass Transfer 52 (2009) 2834–2848. https://doi.org/10.1016/j.ijheatmasstransfer.2008.09.039

A. standard 93-97, 1977.

R. Kumar, V. Goel, P. Singh, A. Saxena, A.S. Kashyap, A. Rai, J. Energy Storage. 26 (2019) 100978. https://doi.org/10.1016/j.est.2019.100978

F. Afshari, A. Sözen, A. Khanlari, A.D. Tuncer, C. Şirin, Renewable Energy 158 (2020) 297–310. https://doi.org/10.1016/j.renene.2020.05.148

R. Khatri, S. Goswami, M. Anas, S. Sharma, S. Agarwal, S. Aggarwal, Energy Reports 6 (2020) 627–633. https://doi.org/10.1016/j.egyr.2020.11.177

C.D. Ho, H. Chang, R.C. Wang, C.S. Lin, Appl. Energy 100 (2012) 155–163. https://doi.org/10.1016/j.apenergy.2012.03.065

A.A. Farhan, A. Issam M.Ali, H.E. Ahmed, Renewable Energy 169 (2021) 1373–1385. https://doi.org/10.1016/j.renene.2021.01.109

Q.A. Jawad, A.M.J. Mahdy, A.H. Khuder, M.T. Chaichan, Case Stud. Therm. Eng. 19 (2020) 100622. https://doi.org/10.1016/j.csite.2020.100622

R. Azad, S. Bhuvad, A. Lanjewar, Int. J. Therm. Sci. 167 (2021) 107013. https://doi.org/10.1016/j.ijthermalsci.2021.107013

S. Rönsch, B. Auer, M. Kinateder, K. Gleichmann, Chem Eng Technol 43 (12) (2020) 2530-2537. https://doi.org/10.1002/ceat.202000342

Cover

Downloads

Published

29.03.2024

Issue

Articles in Press

Section

Articles

License

Copyright (c) 2023 Sureshkumar Petchimuthu, Sathiya Moorthy Rajendran

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Authors who publish with this journal agree to the following terms:

Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

Authors grant to the Publisher the following rights to the manuscript, including any supplemental material, and any parts, extracts or elements thereof:

  • the right to reproduce and distribute the Manuscript in printed form, including print-on-demand;
  • the right to produce prepublications, reprints, and special editions of the Manuscript;
  • the right to translate the Manuscript into other languages;
  • the right to reproduce the Manuscript using photomechanical or similar means including, but not limited to photocopy, and the right to distribute these reproductions;
  • the right to reproduce and distribute the Manuscript electronically or optically on any and all data carriers or storage media – especially in machine readable/digitalized form on data carriers such as hard drive, CD-Rom, DVD, Blu-ray Disc (BD), Mini-Disk, data tape – and the right to reproduce and distribute the Article via these data carriers; 
  • the right to store the Manuscript in databases, including online databases, and the right of transmission of the Manuscript in all technical systems and modes;
  • the right to make the Manuscript available to the public or to closed user groups on individual demand, for use on monitors or other readers (including e-books), and in printable form for the user, either via the internet, other online services, or via internal or external networks.

How to Cite

Experimental study of solar air heater with C shaped ribs coated with zeolite: Original scientific paper. (2024). Chemical Industry & Chemical Engineering Quarterly. https://doi.org/10.2298/CICEQ231230010P

Similar Articles

41-50 of 59

You may also start an advanced similarity search for this article.